4
DRYING PRINTS
IL887A
IL888A
IL889
ILFOLAB
1250 RC
ILFORD
10
Fill the wet-print dish with
enough cold water to cover
the washed prints. Switch the
electrical supply on. Turn the
dryer control to ‘ I ‘. The red
‘POWER’ light illuminates.
1
2
3
Allow about 1
1/2
minutes for
the orange ‘READY’ light to
switch on. During this time,
transfer the washed prints to
the wet-print dish. As a
guide, set the speed control
to position 6 to dry resin
coated paper sheets.
Feed prints emulsion side up.
Ensure prints are fed
squarely. Feed small prints
with the short edge leading.
Do not overlap one print with
another - allow 2 seconds
between the trailing edge of
one print and the leading
edge of the next.
Summary of Contents for ILFOLAB 1250 RC
