2
CONTROLS AND
INDICATORS
2.1
2.2
2.3
2.4
7
See figure 2.1.
‘POWER’ LIGHT
The red ‘POWER’ light illuminates when the dryer control is
selected to ‘ I ‘ or ‘RUNDOWN’.
‘READY’ LIGHT
The orange ‘READY’ light indicates that the machine has warmed
up and is ready for use.
DRYER CONTROL
The dryer control has three positions:
Position ‘O’
The dryer is switched off.
Position ‘RUNDOWN’
In this position the power supply to the heaters is switched off,
but the fans and main drive continue to run. After a pre-set time
(factory set), the fans and main drive are switched off
automatically.
Note
It is recommended that this position is used before switching the
dryer off at the end of the day. Select this position to remove
moist air from the dryer and to prevent excessive heat retention
in the rollers.
Position ‘ I ‘
For drying sheets. See section 8 for speed range.
SPEED CONTROL
The speed control adjusts the time taken for sheets to pass
through the dryer and, therefore, the rate of drying. The speed
control operates when the dryer control is selected to ‘ I ‘ and is
adjustable over the range minimum setting (slowest) to maximum
setting (quickest).
Figure 2.1
Dryer control
Speed control
1
2
Summary of Contents for ILFOLAB 1250 RC
