3
INSTALLATION
3.1
3.2
3.3
3.4
1
2
3
4
9
See figure 3.1.
PRINT RECEIVE TRAY
Secure the tray with the screws supplied, as shown in detail
B
.
LOCATION
Position the dryer on a firm bench or table at a convenient
working height. The dimensions shown in detail
A
are minimum
requirements to allow for adequate air circulation and for the
print receive tray. Position the wet-print dish under the dryer.
ELECTRICITY SUPPLY
Connect the lead supplied to the dryer mains input plug and to a
standard wall socket. The lead fits one way only.
REMOVING YELLOW TRANSIT WEDGES
See figures 3.1 and 3.2.
CAUTION
To enable the dryer to operate correctly, it is important to remove
the two yellow transit wedges prior to use.
Press the release button on the left hand side of the dryer and
open the dryer until the lid is held by the restraining arm.
Lift the four-roller assembly away.
Remove the two transit wedges from between the roller bearings.
Re-assemble the dryer and close the lid.
IL886
Figure 3.2
Location of transit wedges
Figure 3.1
Release button
Yellow transit wedges
Four-roller assembly
Restraining arm
Feed tray
Mains fuse
Electricity supply lead
Print receive tray
Pan head screw
Wet-print dish
1
2
3
4
5
6
7
8
9
10
Summary of Contents for ILFOLAB 1250 RC
