Ilford ILFOLAB 1250 RC, Operating Manual

Page: 18 / 26

1
2
3
4
5
6
1
2
3
4
5
6
16
To remove the rear rollers, proceed as follows:
CAUTION
This operation requires access to the electrical compartment.
Please refer to the Safety Precautions at the front of this manual.
Switch the electrical supply off.
Press the release button and open the dryer until the lid is held
securely by the restraining arm.
Release the four screws and remove the lower cover.
Carefully remove the upper roller, complete with bearings.
Carry out the following operations only if the lower roller is to be
removed.
Slacken the four nuts securing the print exit guide to the
ventilation grille as shown in detail
B
and push the exit guide
towards the rear of the dryer.
Carefully lift the lower roller, complete with bearings and roller
drive gear, away.
To replace the rear rollers, proceed as follows:
Note
Carry out operations 1, 2, 3, 7 and 8 only if the lower roller is
being replaced.
Ensure the print exit guide is pushed towards the rear of the
dryer and is not obstructing the lower roller.
Replace the lower roller, complete with bearings. Ensure the
roller drive gear meshes with the idler gear.
Replace the upper roller, complete with bearings.
Carefully move the print exit guide towards the front of the dryer
until the rear edge of the mark at each end of the guide is
aligned with the front edge of the ventilation grille. Tighten the
nuts securing the guide to the ventilation grille. Check the
alignment is correct as shown in detail
A .
Refit the lower cover. Secure the cover with the four screws and
washers.
Close the dryer.