Ilco Orion Rigel, Operating Manual

Page: 21 / 26

Operating manual - English RIGEL EU
19
8.2 Replacing the brush
When the brush no longer cleans off the burrs it must be replaced as follows:
ATTENTION:
Remove the mains plug
.
1) Place the spanner provided in position on the motor shaft.
2) Use the Allen wrench to loosen the screw holding the brush in place .
3) Replace the brush and tighten the screw with the Allen wrench.
4) Remove the spanner from the motor shaft.fig. 14
Fig. 14
8.3 Replacing the belt
Worn or loose belts must be replaced or adjusted so as to ensure safe and proper operation of the cut-
ting tool/ brush.
Replacement:
ATTENTION: Remove the mains plug.
1) Remove the motor cover (N).
2) Loosen the four screws which fix the motor (S) to the base.
3) Raise the motor and remove the worn belt.
4) Fit the new belt.
5) Push the motor down until the proper belt tension is obtained.
6) Tighten the four screws.
8.4 Replacing the tracer point
To replace the tracer point (I), proceed as follows :
ATTENTION: Remove the mains plug.
1) Remove the motor cover.
2) Loosen the screw (J)
3) Loosen the grub screw (Z).
4) Loosen the tracer point by turning it anticlockwise until is fully released.
5) Fit the new tracer point.
6) Tighten the grub screw (Z).
7) Tighten the screw (J).
8) Re-set the machine as described in chap. 6, page 13.
Fig. 15
brush screw
P1
motor screws
S
N
J
Z
I