RIGEL EU
Operating manual - English
4
GENERAL INTRODUCTIONS
The RIGEL EU key-cutting machine has been designed according to the specifications of the Machine
Directives. From the design stage risks for the operator have been eliminated in all areas: transport,
key-cutting, regulation and maintenance.
Other risks have been eliminated by the use of protective devices for the operator.
The protective devices used are designed not to provoke further risks and, above all, they cannot be
ignored unless deliberately cut out. They do not hinder visibility of the work area.
A special adhesive label is attached to the machine warning the operator to use goggles during the cut-
ting operations, and this is strongly recommended in this manual.
The material used in the manufacture of this machine and the components employed during use of the
machine are not dangerous and their use complies with standards.
Use
The RIGEL EU must be installed and used in the way laid down by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this ma-
nual, the customer will forego any rights he may have over ILCO ORION . Furthermore, unforeseen dan-
ger to the operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine or failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility
in such cases.
It is therefore indispensable to read the operating manual carefully in order to make the best use
of the RIGEL EU and benefit from its potential.
Further Risks
There are no further risks arising from the use of the machine.
Protection and safety precautions for the operator
The RIGEL EU key-cutting machine is built entirely to standards. The operations for which it has been
designed are easily carried out at no risk to the operator.
The adoption of general safety precautions (wearing protective goggles) and observation of the instruc-
tions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
The RIGEL EU key-cutting machine is designed with features which make it completely safe in all its
parts.
•
Power supply
The key-cutting machine is powered directly by electricity supplied through a safety device. The mains
plug must be earthed.
•
Start-up
The machine is started up:
-
by means of the START button on the safety device (standard with 230V key-cutting machines, on
request for other voltages).
-
by means of the motor start-up switch on the left-hand side.
•
Maintenance
The operations to regulate, service, repair and clean the machine have been devised in the simplest
and safest way possible. There is no danger of removable parts being re-placed wrongly or unsafelyo.
•
Machine Identification
The RIGEL EU key-cutting machine is provided with an identification label which shows the serial num-
ber (fig. 2).
Fig. 2
(*) see chap.9 WASTE DISPOSAL, page 21.
Summary of Contents for Rigel
Page 1: ...Operating manual DMS200372 vers 3 0 RIGEL EU ...
Page 4: ......
