Doc ID:IKUSI OP-13TX Optical Transmitter User Manual V1
Page
6
of
13
© 2018 IKUSI ANZ Pty Ltd - All rights reserved - Reproduction without consent is prohibited
02-May-2018
Chapter 2 Installation Guide
This section explains precautions required when installing device
2.1 General Precautions
✓
Must be operated and maintained free of dust or dirt.
✓
Do not remove cover as this will void warranty.
✓
Check device is not damaged due to transport, prior to installation.
✓
Advise supplier of any damage
✓
Save the shipping boxes and their inserts for any future reshipment for upgrade or repair.
2.2 Power precautions
✓
Only Australian standard power cable should be used.
✓
Avoid operating in a wet or moist environment.
✓
Make sure the power switch is off, before you start to install the device
✓
NOTE: In the event of a reshipment back to the manufacturer, any additional damages caused by
not using the original boxes will be considered responsibility of the customer.
2.3 Installation Flow Chart
Device
Check
On
Receipt
Run Device
Installing
Device
Connect
Earth wire
and power
cord
Connect
signal
source
Setting
Parameters
