Doc ID:IKUSI OP-13TX Optical Transmitter User Manual V1
Page
12
of
13
© 2018 IKUSI ANZ Pty Ltd - All rights reserved - Reproduction without consent is prohibited
02-May-2018
3.1.3 Menu Operation
1.
The initial RF Mode =AGC, The OMI menu displays RF Mode= ;
At this time. If you press "SELECT", it will display RF Mode= ;
Press "▲"or "▼", the menu displays: RF Mode=Manual.
2.
If display shows "INTERLOCK", and Red Led Flashing, it means the remote connection point
at the back panel is lost.
3.
If RF input level is too high, there will be alarm and Red led flashing, lower the RF power input
power transmitter down and turn on again.
4.
+5V voltage (+5V READS) >±0.5V alarm.
-5V voltage (-5V READS) >±0.5V alarm.
5.
If any fault occurred, there will be alarm (Red led flashing), Microprocessor will cut down the
laser automatically, and digital panel show the cause of the fault.
4.0 Carrier to Noise Performance
(59 route PAL-D
，
CTB=65dB
，
CSO=60dB)
Link loss
(dB)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
OP-13Tx
56.0
55.0
54.0
53.0
52.0
51.0
RF level decides the OMI of the laser and the system index.(CNR, CTB, CSO). When at 59 route PAL-D, its
RF level is 20dBmV. Suppose channel is N
Si(N)=20+10Lg(59/N) (dBmV)
CNR and Channel N
CNR(N)=CNR(59)+10Lg(59/N) (dB)
5.0 LAN & RS232 Interface
There are 2 connections 1 x RG45 & 1x RS232 on rear panel.
