Ikegami OCP-10, Operation Manual

Page: 24 / 63

8
2.4 ENABLE Switch
It enables OCP operation.
When the switch is lit on, control from the OCP is available.
2.5 AWB Switch
It performs AWB (Auto White Balance).
When AWB is completed, the lamp lights off. When AWB fails, the lamp blinks.
After checking the failed state, press the blinking switch again to reset the failed
state.
Holding down the AWB switch enables execution of Quick Auto Setup.
Caution
: Depending on the camera, this function may not activate even when the
switch is held down for a while.
2.6 ABB Switch
It performs ABB (Auto Black Balance).
When ABB is completed, the lamp lights off. When ABB fails, the lamp blinks.
After checking the failed state, press the blinking switch again to reset the failed
state.
Holding down the ABB switch enables execution of Auto Black Shading.
Caution
: Depending on the camera, this function may not activate even when the
switch is held down for a while.
2.7 SCENE File Switch
It saves and loads the scene files 1 to 8.
When selecting the scene files, the character indicator and the rotary switch are used.
Reference
: Refer to "5. Rotary Switch" for the method to save the scene files.
The scene file ON state is indicated when the switch is lit on. The scene file OFF
state is indicated when the switch is lit off. In addition, holding down the switch
saves the scene file.
Note
:
To set controls to the center after loading a scene file, use the knob free
function.