Ikegami FA-55, Operation Manual

Page: 129 / 160

113
i
6
■
SMPTE type Connectors
7KHIROORZLQJH[SODLQVKRZWRFOHDQ)HUUXOHVXVLQJD6037(W\SH/HPR.VHULHVRUFRPSDWLEOHSURGXFW¿EHUFDEOHSOXJIHPDOH
as an example.
CAUTION:
When removing the alignment sleeve, be sure to use a dedicated optical contact extractor
'&&/$$OVRXVHWKHHQGRIWKHH[WUDFWRUWKDWKDVDQLQQHUWKUHDG
1
Prepare a dedicated extractor and place the extractor in a position parallel to the connector.
②
emove the cap
Se
ra r
T read
2
Remove the cap of section A (with a thread).
③
Insert the e tractor into the
alignment sleeve turn and pull out.
Ferr e
me ee e
ra r
me ee e
3
Insert the extractor into the alignment sleeve
and turn the extractor clockwise 8 to 10 turns
until it stops. When it stops, pull the extractor out
straight.
Leave the alignment sleeve attached to the extractor.
④ ipe with a cotton swab dampened
with alcohol.
Ferr e
d e am e
Cr e
Ferr e
Bad e am e
Cr e
Ferr e
4
Wipe the Ferrule with a cotton swab dampened
with alcohol.
CAUTION:
- When you wipe the Ferrule, move the cotton swab
straight in a way in which you brush the dust off the
Ferrule. Do not wipe back and forth or in a circle. Doing
so may spread the dirt instead of removing it.
- Do not blow your breath on the Ferrule.
5
After wiping the Ferrule with alcohol, wipe the Ferrule with a dry cotton swab.
6
Make sure that the dirt is removed.
Use a loupe to examine the Ferrule.
7
Wipe the electrical contact and alignment sleeve in the same way.