IKEA SULTAN ALSVAG, Manual

Page: 4 / 24

4 45
ENGLISH
INSTRUCTION DOCUMENT REGARDING
SULTAN ALSVÅG BED
Manufacturer: IKEA of Sweden
Protection class: IP 20
Recommended relative humidity: 30% -
75%
Recommended ambient temp.: +10° -
+40°C
Each user of this product should carefully
read these instructions.
General information
The bed is operated by electric motors.
The bed is adjusted by using the remote
control.
The head and foot sections are separately
adjustable.
The motors stop automatically in the
upper/lower end position.
The bed is overload protected by a
temperature fuse.
Installation instruction
Connect the transformer and the remote
control to the motors. As a strain relief for
the plug the electric cables has to be fixed
to the cable guide as shown in figure 3-4.
Put the plug in a wall socket.
Place the electric cables so that they are
protected from damage.
The electric cables shall be allowed to
move freely.
Insert the batteries into the remote control
as shown in figure 2.
Instructions for use
The bed shall only be used as a bed
allowing infinite adjustment of both
the head section and the foot section,
separately or together.
To adjust the position of the bed upwards/
downwards, press the button with up/down
arrow on the remote control.
The bed stays in the desired position when
the button is released.
Do not adjust the bed upwards and
downwards repeatedly.
If the bed is overloaded, the motors will
stop. Wait for a while and then try again.
The bed should be placed with space
around it.
In case of a power cut out both the head
section and the foot section can be lowered
manually. For instruction see figure 5. To
re-engage the drive after manual lowering,
see figure 6.
Safety instructions
Do not sit or stand on either the head
section or the foot section unless the bed is
in its horizontal position, see figure 8.
Adjustment of the bed upwards or
downwards is associated with a certain
squeeze hazard. To minimize this risk, take
the following precautions:
The distance between the bed and
surrounding fixed objects (bedside table,
window-sill etc.) shall, to prevent the risk
of squeezing of arm, be minimum 12 cm (4
3/4”), and to prevent the risk of squeezing
other parts of the body, minimum 50 cm (19
3/4”).
To eliminate other squeeze risks, there shall
be an adequate distance to surrounding
objects.
While adjusting the bed upwards or
downwards the user shall keep a strict
watch to prevent injury to other persons
and damage to surrounding objects.
Make sure the wall socket is always easy
accessible.
AA-420171-2