Ikco DONG FENG H30 2016, Owner'S Manual

Page: 18 / 166

17
1
REMOTE CONTROLLER
Battery run-out
When the remote controller fails to
operate normally at a distance shorter
than 6m, have the battery inspected
or replaced at either Dongfeng
Franchise Store or IKCO authorised
representatives.
Replacement of remote controller
battery
Open the remote controller box to
replace the battery.
Battery: 3V CR2032
Note:
To protect the environment, do
not throw away the waste battery but
send it to the designated recovery place.
Activation/deactivation of automatic
locking during driving
The automatic locking function can be
activated or deactivated as follows:
- Turn the ignition switch to M position
when the vehicle is stopped.
- Press down the locking button on
the door at the driver’s side for 2s.
Afterwards, the dot-matrix multi-
function display will show the indicating
words and the symbol of “manual ”
or “automatic ”. Pressing and holding
the locking button will enable a
switch-over between activation and
deactivation of the function. The
segmentcode type multi-function
display will show the symbol of “manual
” or “automatic ” only, without the
indicating words.
Automatic locking during driving
After the vehicle is started and runs at a
speed more than 10km/h and all doors
(incl. trunk lid) are closed, the door locks
will be locked automatically, unless the
doors (incl. trunk lid) are not properly
closed.
This function can prevent other people
from pulling the door open and entering
into the vehicle when the vehicle stops
at the red traffi c light or in other cases,
but will also inhibit the rescue by others
in accidents. Whether to activate this
function is up to the driver.