Tie rod M2x12 mm
Quick link
Servospacer 3 or 5 mm
Ballend, short
Tie Rod M2x52 mm
Ballend, long
Ball
M2x8 mm LH Screw
M2 mm Nut
67582
6 mm
67576
67603
17 mm
67527
67523
67520
67564
67533
67565
67576
67603
67582
1x
1x
2x
1x
1x
2x
1x
1x
1x
abt. 45 mm
The length may vary according to the final
servo position. Make sure that the mixer
base plate is exactly in the center of the
main frame and the 90° levers are at a right
angle.
67565
67565
67527
Use a 3 or 5 mm Servo
spacer, 67520,
depending on your servo
View from the top.
Make sure that the rod doesn't touch the main
rotor shaft in any position. Use the 3 or 5 mm
spacer to get a suitable servo position
You will see now how the mixer works:
The pitch servo moves the base plate backwards.
The elevator, aileron and tailrotor servo remain
unchanged. The 90° levers "translate" the horizontal
movement of the ground plate in vertical movement
of the tie rods to the swashplate. The swashplate
wards and increases the pitch value of the manrotor.
At the same time, the mixer lever for the tailrotor
pulls the tailrotor snake giving increased pitch to the
tailrotor blades.
The system is simple but effective. It allows you to
use a standard 4 -Channel R/C. With a Y-connector
the pitch signal is relayed to the speed controller.
Increasing pitch will automatically increase the motor
rpm.
max. pitch
+9°
hoover pitch
+5° until +6°
min. pitch
-1° until -2°
Our speed controller Heli 4000 (No.:720667) is
already installed with an exact throttle curve.
