87411
3
age
PRO . S Y S TE M
Contents
Dinoz x 1
Transmitter x 1
Water Pump x 1
Instruction Manual x 1
Battery Precaution
1. Alkaline batteries are recommend
Battery Requirement
1. Dinoz: 4 x 1.5V AA batteries
2. Transmitter: 2 x 1.5V AA batteries
4 x AA
For Dinoz
( Included )
2 x AA
For Transmitter
(Not Included )
2. Only batteries of the same or equivalent type as recommended are to be used
3. Do not mix alkaline, standard, or rechargeable batteries
4. Do not mix old and new batteries or different types of batteries
5. Non-rechargeable batteries are not to be charged
6. If rechargeable batteries are to be used, they are only to be charged under adult supervision
7. Rechargeable batteries are to be removed from the product before they are charged
8. Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions
9. Remove all batteries from the Dinoz and Transmitter when not in use
10. Exhausted batteries are to be removed from the product
11. The supply terminals are not to be short-circuited
12. Dispose of batteries properly / do not dispose the batteries in fire - it may cause them to explode or leak causing injury or damage
13. Battery installation and removal must only be done by an adult
Battery Installation
For Dinoz (Fig. 1 and Fig. 2)
1. Switch the power button to OFF position
2. Unscrew the battery cover
3. Open the battery cover
4. Install 4 new 1.5V”AA” batteries with correct polarities (+/-)
5. Close the battery cover
6. Tighten the screw on the battery cover
For Transmitter (Fig. 3 and Fig. 4)
1. Unscrew the battery cover
2. Open the battery cover
3. Install 2 new 1.5V “AA” batteries with correct polarities (+/-)
as shown inside the battery compartment
4. Close the battery cover
5. Tighten the screw on the battery cover
Fig. 1
Dinoz
Fig. 2
Dinoz
Fig. 3
Transmitter
Fig. 4
ON/OFF
& Try Me
1.5V
AA
_
+
+
+
_
_
+
Move Forward/
Backward
2.4 GHz
Signal Light
Light, Sound
& Smoking
Effect
Transmitter - Battery Installation
How to fill with water for smoking effect
1. Please prepare a cup of clear tap water. Keep
squeezing and releasing the provided water
pump to fill with the water. (Fig.5)
3. Squeeze the provided water pump to fill the
water tank into the Dinoz. (Fig.7)
2. Open the water tank cap on the Dinoz. (Fig.6)
4. Close the water tank cap firmly. (Fig.8)
