IKA RV 10 auto, Operating Instructions Manual

Page: 12 / 160

12
Item Designation Quantity
RV 10.1 non-coated
RV 10.10 coated
RV 10.2 non-coated
RV 10.20 coated
RV 10.3 non-coated
RV 10.30 coated
RV 10.4 non-coated
RV 10.40 coated
RV 10.5 non-coated
RV 10.50 coated
RV 10.6 non-coated
RV 10.60 coated
1 Receiving flask 1 1 1 1 1 1
2 Clamp (stainless steel) 1 1 1 1 1 1
4 Stopcock 1 1 1 1 1 1
5 Pipe tube 1 - 1 1 1 1
6 Condenser 1 Vertical condenser 1 Diagonal condenser 1 Vertical-intensive
condenser
1 Dry ice condenser 1 Vertical condenser 1 Vertical-intensive
condenser
7 Connection 1 Vacuum connection 1 Introduction sleeve 1 Vacuum connection - 1 Vacuum connection 1 Vacuum connection
8 Clamp (plastic) 1 1 1 - 1 1
10 Evaporation flask 1000 ml 1 1 1 1 1 1
11 Ball joint clamp RV 05.10 1 1 1 1 1 1
12 Screw joint cap 4 4 4 2 4 4
13 Hose connection 4 4 4 2 4 4
14 Manifold - - 1 - 1 1
15 Cover cap - - - 1 - -
16 Cartridge - - - 1 - -
17 Ring, slotted - - - 1 - -
18 Washer 1 - 1 1 1 1
19 O-ring - - - 1 - -
20 Plug, high vacuum - - - - 1 1
Note:
The PTFE tube (5) with the washer (18) can be mounted optionally on the vertical glass sets.
It serves for filling the evaporator flask when there is a vacuum in the glass set.
Solvent can be sucked through the PTFE tube into the evaporator flask by opening the stopcock (4).
Mounting the glassware
Note: Observe "Drawings for mounting the glassware" on page 154.
Mounting the washer
Drainage washer
Note: Pay attention to the correct position of the washer.
Removing the condenser
• Use the ring spanner provided to loosen union nuts that are
tightly fitted.
• Loosen the union nut by turning counterclockwise.
• Remove the Velcro
®
.
Note: Ring spanner is only used for removing the condenser,
while fixing the condenser please use hands.