5
Japanese/Englishselectionfunction
Japaneseisthefactorydefaultsettingforthedisplay.The
displayedlanguagecanbeswitchedbetweenJapanese
and English from any screen.
Usually, the language can be switched between Japanese and English from any screen if the power is ON. Note that the
language cannot be switched during the following operations. The language can be switched once the operation is fin-
ished or canceled and the built-in pump has stopped.
• During O
2
/CO
2
measurement operation
• During calibration (span calibration/zero calibration) operation
• During the clogging check operation
1.
With the power turned ON, hold down the
for 3 seconds
or longer.
The display language will switch from Japanese to English.
(The displayed contents are saved.)
Hold down for
3 seconds or
longer
JapaneseEnglish
2.
When the
is held down again for 3 seconds or longer, the language will return to
Japanese.
<WhenusingincountriesorregionsotherthanJapan>
By using the “Time zone selection function,” the time zone can be set to the standard of the region
where the instrument is being used.
Refer to “Time zone selection function” on page 14 for the operation methods.
