SuperiorFireplaces.us.com
900463-01E
17
INSTALLATION
Continued
9. If logs were removed from appliance for install
remote accessory, replace logs (see
Installing
Logs
,
Embers and Volcanic Stone,
Page 18
).
10. Place remote receiver on fi replace fl oor next to
control valve. Make sure the remote receiver and
wires are not on or touching either gas burner
on the log set.
Installing Batteries for Remote Receiver and
Hand Held Remote Control
Two 9-volt alkaline batteries (not included) are
required to operate this appliance with the wireless
hand-held remote control set. One battery must be
installed in the receiver and one in the hand-held
remote control unit.
NOTE: Only use alkaline batteries.
Figure 19- Disconnecting Switch from Control Valve
(Remote Ready Models Only)
Switch
Control
Valve
3. Replace battery housing cover.
When batteries are installed, the "little house" icon
with current room temperature will be displayed
(see
Figure 21
).
This icon will always show in the
control window as long as the batteries have power.
Figure 21 - Remote Display
+
+
-
+
-
-
AAA
AAA
AAA
Figure 20 - Battery Install Hand-Held Remote Control
Battery Housing
Cover
Figure 22 - Battery Install Remote Control
Receiver
Battery Housing
Cover
Cover Plate
Screws
Receiver
Remote Receiver
The remote receiver uses 4 AA batteries (not in-
cluded).
To install or replace batteries:
1. Open lower louver to gain access to receiver.
2. Remove screws from cover place.
3. Remove battery housing cover.
4. Install or replace batteries.
5. Replace battery housing cover.
6. Replace cover plate.
WARNING: Make sure your selec-
tor switch is in OFF position before
installing or changing batteries in
your hand-held remote or receiver.
INSTALLING BATTERIES IN REMOTE
CONTROL AND RECEIVER (VARIABLE
REMOTE MODELS)
Hand-Held Remote Control
The hand-held remote control uses 3 AAA batteries
(not included).
To install batteries:
1. Remove battery housing cover from back of
hand-held remote
(see
Figure 20
).
2. Install or replace batteries.
