Shown at left is the foot valve connected and
lying on the bottom of a tank.
At the top of the picture, you can see there are
two clear hoses connected to the foot valve.
Connect these two hoses to the foot valve with
the larger hose connected to the applicable
piping and the smaller hose connected to the
smaller pipe.
Secure both hoses with the supplied clamps
and tighten to a normal tightness for this type
of fitting. There is no need to overtighten
either of these connections.
The other end of the larger hose is connected
to the fitting found on the lower left side of
the unit and inside the unit. Feed the hose
though the hole provided. This connection is
in front of the discharge connection and is
easy to recognise as it is a push on fitting and
not screwed on.
As with the foot valve, use the supplied clamp
to tighten the connection. Normal tightness is
sufficient and there is no need to overtighten.
The smaller suction hose is connected to the
primer pump as shown here. Feed this hose
through the hole provided on the left-hand
side of the unit and connect as shown in the
photo to the left.
As with the other clamps tighten as needed
without over-tightening.
