17
UK
Operation
10
After power on of the supply voltage the unit is in the Run mode (= normal operati-
on)� It carries out its measurement and evaluation functions and generates output
signals according to the set parameters�
Operation indicatin → chapter 7 Operating and display elements.
Read the set parameter values
10.1
Press [Mode/Enter] until the requested parameter is displayed�
►
Press [Set] briefly�
►
The unit displays the corresponding parameter value for about 15 s� After
>
another 15 s the unit returns to the Run mode�
Fault indication
10.2
[OL]
Overload pressure (measuring range exceeded)�
[UL]
Underpressure range (measuring range below the minimum value)�
[Err]
Internal fault, invalid input (indicated even if the display is deactivated)�
Cleaning of the filter cover
10.3
If viscous and residues producing
media clog the filter cover of the sen-
sor (and thus reduce the measuring
accuracy slightly), you can clean it�
Unscrew the filter cover (B) (use a
►
pair of pliers with plastic-covered
jaws for this)�
Clean the cover thoroughly�
►
� �
The vent (A) should only be cleaned by skilled personnel and with utmost care�
Possible medium residues must not be compressed and pressed into the vent�
This could clog the filter system and reduce the measuring accuracy of the
sensor�
Screw the filter cover again tightly�
►
