![background image](http://html1.mh-extra.com/html/ifm/basiccontroller-cr0431/basiccontroller-cr0431_programming-manual_3915933027.webp)
27
ifm
Programming Manual BasicController relay CR0431 v03.03.00
05 / 2018
System description
Software description
>
Note the cycle time!
8006
For the programmable devices from the controller family
ecomatmobile
numerous functions are
available which enable use of the devices in a wide range of applications.
As these units use more or fewer system resources depending on their complexity it is not always
possible to use all units at the same time and several times.
NOTICE
Risk that the device acts too slowly!
Cycle time must not become too long!
► When designing the application program the above-mentioned recommendations must be
complied with and tested.
► If necessary, the cycle time must be optimised by restructuring the software and the system
set-up.
>
Important note to program the device
20763
Applies to the following devices:
• BasicController relay CR0431
► For the time of programming interconnect the connections B:1 (VBB15) and B:8 (VBBs).
Otherwise programming is not possible.
Background:
The controller resets all outputs when programming begins, also SUPPLY_SWITCH.
Without VBB15 the controller would be separated from the voltage supply and is switched off.
When the controller is switched on again, the device is in bootloader mode.
The programmer has to load the Basic System to the device again.
Then reload the application program to the device.
Summary of Contents for BasicController CR0431
Page 228: ...228 10 Notizen Notes Notes...