IEMCA KID 80 IV Touch, Instruction Manual

Page: 39 / 122

2 - INFORMATION FOR USE KID 80 SIV
EN
2 - Pag. 25 / 71
no. 4 Short feeding safety
During every feeding stage, it checks that the
bar does not go further than the value set in
parameter 6 and keeps the tolerance level set
in parameter 4. Should this not occur for any
reason, when the lathe cuts the "FEEDING"
signal, the bar feeder goes into "ALARM".
If parameter 6 is set to 0, this parameter is not
active.
A - Parameter 4
B - Parameter 6
0 - (Not enabled for first piece); the parameter is active for all feeding operations except for
the first piece.
1 - (Enabled for first piece): the parameter is active for every feeding operation (the facing
phase excepted).
INFORMATION
The short piece control cannot be performed in sliding headstock lathes (bar
feeding is carried out by the headstock).
INFORMATION:
Setting the subparameter to 1 (Enabled for first piece), the "short piece"
(parameter 4) checks are activated straight after the first piece.
4
no. 4 Short feeding safety
DEFAULT VALUE PROGRAMMABLE VALUE
Kid 80 Kid 80
0 /