GB
6 - USE AND OPERATION
BOSS 332/545/551 E-volution
6 - Pag. 16 / 19
6.5.5
Cycle actuation mode in the STEP BY STEP function
Introduction
This mode can be used for many reasons, as for instance:
• to check a complete bar change cycle;
• to check the bar feeder mechanics;
• to load a single bar with the intent of checking the facing;
• eccetera.
Procedure
•
Press
to start the bar feeder.
•
Check that the bar feeder is under closed guide channel conditions.
•
Press
plus
to select the semiautomatic function.
•
Press
, the bar feeder performs the first step.
•
Press
, the bar feeder performs the second step, and so on.
6.6
FEEDER STOP
FEEDER EMERGENCY STOP
CAUTION:
if the emergency stop is used during lathe machining, before resuming work
make sure that the sudden stop has not created any hazardous condition (e.g., if
the tool was cutting chips, move the tool away from the workpiece before
restarting the lathe).
• To stop the feeder in an emergency, press an emergency push-button, either that of the
lathe or that of the feeder.
FEEDER STOP AT WORK END
CAUTION:
do not use emergency buttons for normal machine stop.
• Complete the operations in your work schedule.
• Stop the feeder by pressing the button
.
• Stop the lathe.
• Turn the main power switch to the position O (OFF).