Print More Materials, All For Application
— 41 —
7.2 Temperature
Problem
Solution
Problem one: click on the heating, the
temperature does not change, a few seconds
later prompted the heating power is insufficient,
check the heating head temperature rise
Attention: temperature measurement careful of
high temperature hot hands
Whether the print head is installed, or whether
the wire is connected
7.3 Print
Problem
Solution
1. Prompt 1 or 2 no material, cannot be printed
properly
Add filament at the filament break detection, if it still
indicates no filament, replace the filament break
detection limiter
2. Print appears to be detached from the bottom and
is carried away
1. to determine the platform to be able to print
the material, adjust the platform and nozzle gap when
the zero point is small (for details, see the bottom
plate leveling - steps 9, 10, 11, 12)
2., the first layer of the printing speed is too fast.
3. it is important to adjust the temperature of the
flat hot bed and the setting parameters of the fan
cooling
4. and platform coating or media related, may
have damage to the coating or media
3. Double-headed printing does not work well
together
According to the maintenance - nozzle spacing
adjustment spacing
4. Not extruded at the beginning of printing
1, The nozzle is too close to the platform, there is no
space for the silk, adjust the nut at the bottom of the
platform can be solved.
2, The feed gear cannot drive the gum silk normal out
of the silk, you need to check this part, motor gear
powder, if more, please clean together.
3, Nozzle blockage, it is recommended that the use of
a fine needle inserted into the nozzle solved the
problem of head blockage.