IEI Technology iSignager-1000-Q354, User Manual

Page: 138 / 189

iSignager-1000-Q354 Digital Signage Player
Page 124
8.3.2 Configure the Jumper Settings
To configure the jumper settings, please follow the steps below.
Step 1:
Remove the cover case. See
Section 8.3.1
.
Step 2:
Locate the jumper settings on the embedded motherboard. See
Section 3.3
.
Step 3:
Make the jumper settings in accordance with the settings described and defined
in
Section 3.3
.
Step 0:
8.3.3 Expansion Card Installation (Optional)
Some iSignager-1000-Q354 models are preinstalled with a PCIe riser card for an
expansion card. To install an expansion card, please follow the steps below.
Step 1: Remove the slot cover
. The expansion card slot on the rear panel of the
iSignager-1000-Q354 is covered with a cover. To remove the cover, remove the
retention screw on the slot cover (
Figure 8-4
) and the retention screw on the
rear panel (
Figure 8-4
).
Figure 8-3: Expansion Slot Cover Retention Screw