IEI Technology iSignager-1000-Q354, User Manual

Page: 136 / 189

iSignager-1000-Q354 Digital Signage Player
Page 122
Step 1:
Check that the power cable connector on the rear panel is properly plugged into
the power source.
Step 2:
Make sure the power button is turned on.
Step 3:
Plug the system into a monitor and check to see if anything appears on the
screen. If the boot-up screen appears it means the power LED has become
disconnected. To fix this problem, remove the cover case and reconnect the
power LED to the motherboard.
Step 0:
If the above steps have been completed and the system still doesn’t turn on, please do the
following.
Step 1:
Remove the cover case (
Section 8.3.1
)
Step 2:
Check that the power connector on the motherboard is properly connected to
the power supply.
Step 3:
Check that the power button cable connector is properly connected to the
motherboard.
Step 4:
Make sure the cable connecting to the power supply are properly attached and
have not become separated.
Step 5:
Make sure the cable connecting the power button to the motherboard is still
properly attached to the power button and has not been separated.
Step 0:
8.2.2 The System Doesn’t Boot Up
If the system doesn’t boot up please do the following:
Step 1:
Check the power is turned on. See
Section 8.2.1
above.
Step 2:
Make sure the DIMM module is properly installed.
Step 3:
Reset the system using the reset CMOS jumper.
Step 0: