IEI Technology ECK-3699GH, User Manual, Page: 67 / 181

ECK-3699GH Embedded System
Step 1: Remove the top cover. See Section 4.2.3.1 above.
Step 2: The HDD bracket is attached to the chassis by four retention screws. Remove
the four retention screws from the chassis.
Step 3: Attach the HDD to the HDD bracket. To do this, align the four retention screw
holes in the base of HDD bracket with the retention screw holes on the bottom of
the HDD. Insert four retention screws into the bracket on the bottom of the HDD
Step 4: Install the HDD bracket into the ECK-3699GH.
Step 5: Connect the IDE/SATA cable from the IDE/SATA connector on the motherboard
to the rear of HDD.
4.3.6 Cable Connections
The following cables can be connected to the rear panel of the system.
VGA cable connector
Serial port connector
RJ-45 connectors
Parallel port connector
USB devices can be connected to the system
Audio devices can be connected to the system
Keyboard and mouse can be connected to the system
The cable connection locations are shown in Figure 2-4 .
4.4 Power-On Procedure
4.4.1 Installation Checklist
WARNING:
Make sure a power supply with the correct input voltage is being fed into
Page 67