IEI Technology ECK-3699GH, User Manual, Page: 57 / 181

ECK-3699GH Embedded System
4.2.2 Unpacking
After the ECK-3699GH is received make sure the following components are included in
the package. If any of these components are missing, please contact the ECK-3699GH
reseller or vendor where it was purchased or contact an IEI sales representative
immediately.
1 x Embedded system
1 x KINO series motherboard (pre-installed)
1 x DC-to-DC power converter (pre-installed)
2 x Cooling fans (pre-installed)
Other items that should have come with the system are listed below:
1 x CPU cooler
1 x Screw set
1 x SATA cable
1 x 44-pin IDE cable
1 x 40-pin IDE cable
1 x (20+4)-pin power cable
1 x Optical drive converter module
1 x Power adapter
1 x Power cord
1 x Driver CD
1 x User Manual CD
1 x QIG
4.2.3 Opening the ECK-3699GH
Before the jumper settings can be configured and the DIMM memory module and 2.5”
HDD can be installed, the top cover or the bottom surface access panel must be removed.
4.2.3.1 Top Cover Removal
To remove the top cover, please follow the steps below:
Step 1: Remove the three top cover retention screws. The top cover is secured to the
chassis with three retention screws at the rear panel of the chassis.
Page 57