IEI Technology ECK-3699GH, User Manual, Page: 153 / 181

ECK-3699GH Embedded System
7.3.2.2 Motherboard Installation
To install the new motherboard, please follow the steps below.
Step 1: Install the previously removed CPU heat sink.
Step 2: Install the previously removed DIMM
Step 3: Install the new motherboard into the system. When installing the new
motherboard make sure the external peripheral device connectors are properly
aligned with the I/O shielding in the system rear panel.
Step 4: Reinsert the four previously removed motherboard retention screws ( Figure
7-3 .)
Step 5: Reconnect the following cable connectors ( Figure 7-2 ):
Power connectors
Front panel connector
USB connector
Fan connectors
SATA/IDE connector (if connected)
Step 6: Replace the top cover. Once replaced reinsert the three previously removed
retention screws.
Step 7: Reconnect the peripheral devices to the peripheral device connectors on the
rear panel.
Step 8: Power up the system. Step 0:
7.3.3 Power Module Replacement
Power module replacement includes the following two procedures:
Step 1: Removing the power module
Step 2: Installing the replacement power module Step 0:
Page 153