IDTECK FINGER006SR, User Manual

Page: 43 / 48

p.38 The device dose not communicate with PC.
In the case of RS485 communication
See [Communication] > [RS422 Communication Port Connection] of the manual and check i
f the wiring is good.
FGR006 RS422/232 converter
Yellow wire RS422-Tx[-] Rx-
Gray wire RS422-Tx[+] Rx+
Blue wire RS422-Rx[-] Tx-
Brown wire RS422-Rx[+] Tx+
3.2 Please check if the communication ID is good.
Check communication address setting of software and the device.
1. Check if communication ID set in the device is same with communication ID set in a soft
ware.
See [Communication] > [Board ID Setting for RS485 / RS422 Communication] and chec
k a communication address set in the device.
2. When you use several devices together, communication addresses set in the devices sh
ould be different from each other.
3. Check if baud rate is same with baud rate set in a software.
* If you initialize the device, baud rate is set to 9,600 bps which is the default.
3.3 Please check if the communication port setting is good.
Check if communication port set in software is same with communication port set in PC.
If the problem persists, please contact service center.