Section: 2
IDS X64 Remote Receiver 700-408-02A Issued August 2010
20
LED Keypad
1.
Hold the
[*]
key until the beep (3-4 seconds).
2.
The READY and ARM LEDs flash alternately.
3.
Enter
[MASTER CODE]
followed by the
[*]
key.
4.
The READY LED flashes.
5.
Enter
[2] [9]
followed by the
[*]
key.
6.
The READY and ARM LEDs flash simultaneously.
7.
Enter
[RECEIVER NUMBER]
, which could be 1, 2, 3, or 4, followed by the
[*]
key.
8.
The READY and ARM LEDs flash simultaneously.
Zone Led Receiver No.
Zone Led
Capacity
1
9
(x 1 = 0)
2
10
(x 2 = 0)
3
11
(x 4 = 0)
8+64+128
4
12
(x 8 = 8)
=200
5
13
(x 16 = 0)
6
14
(x 32 = 0)
7
15
(x 64 = 64)
8
16
(x 128 = 128)
NOTE:
Remote Receiver 1 is indicated by zone LED 1 coming on.
Remote Receiver 2 is indicated by zone LED 2 coming on.
Remote Receiver 3 in indicated by zone LEDs 1 +2 coming on.
Remote Receiver 4 is indicated by zone LED 3 coming on.
The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.
9.
To identify more receivers repeat steps 7 and 8.
10.
Once you have finished, press the
[#]
key
to exit programming.
3.
Troubleshooting
3.1
Factory Settings
The Remote Receiver leaves the factory with its memory empty.
The Remote Receiver restores its default configuration whenever it finds its memory empty at
startup.
Factory settings (empty memory) may be restored by setting all the DIPswitches to "ON", then applying
(or re-applying) power. When this is done, the Remote Receiver clears its memory then waits with the
red LED quick-flashing in groups of three
R R R R R R R R R R R R R R R
until the DIPswitch is changed to a valid number. The Remote Receiver then restarts normally.
Summary of Contents for X64
