IDS X64, Installer Manual

Page: 15 / 24

Section: 2
IDS X64 Remote Receiver 700-408-02A Issued August 2010
15
LED Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The READY and ARM LEDs flash alternately.
3. Enter [MASTER CODE] followed by the [*] key.
4. The READY LED flashes.
5. Enter [2] [4] followed by the [*] key.
6. The READY and ARM LEDs flash simultaneously.
7. Enter [RECEIVER NUMBER] , which could be 1, 2, 3, or 4, followed by the [*] key.
8. The READY and AWAY LEDs flash simultaneously, and the ARM LED is on.
9. Enter [RELAY NUMBER] followed by the [*] key.
10. The READY LED is on if you are viewing relay 1, and the ARM LED is on if you are viewing relay 2.
Zone LED Property Zone LED Property
1 Secure 9
2 Panic 10
3 Retrigger 11
4 Pulse 12
5 13
6 14
7 15
8 16
11. Enter [PROPERTY NUMBER] which could be 1, 2, 3, or 4, followed by the [*] key.
12. Press the [*] key to scroll to next relay.
13. Once you have finished, press the [#] key to exit programming.
NOTE:

If the Remote Receiver relays are configured as "secure", the effective terminals for "NC"
(Normally Closed) and "NO" (Normally Open) will be swapped.

If retrigger is not enabled, the user will have to wait 30 seconds before they can press a button
again.
If retrigger is enabled, then the user will only have to wait 3 seconds.
2.10 Set Remote Receiver Relay Pulse Time
Use the following steps to set the Remote Receiver relay pulse time.
[*] [Master Code] [*] [2] [5] [Receiver Number] [*] [Relay Pulse Time] [*] [#]
LCD Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The keypad displays “Master Code + *”.
3. Enter [MASTER CODE] followed by the [*] key.
4. The keypad displays “Option Menu”, “Add User Code”.
5. Enter [2] [5] followed by the [*] key.
6. The keypad displays “Receiver Num + *”.
7. Enter [RECEIVER NUMBER] , which could be 1, 2, 3, or 4, followed by the [*] key.