IDS X64, Installer Manual

Page: 19 / 24

Section: 2
IDS X64 Remote Receiver 700-408-02A Issued August 2010
19
LCD Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The keypad displays “Master Code + *”.
3. Enter [MASTER CODE] followed by the [*] key.
4. The keypad displays “Option Menu”, “Add User Code”.
5. Enter [2] [8] followed by the [*] key.
6. The keypad displays “Receiver Num + *”.
7. Enter [RECEIVER NUMBER] , which could be 1, 2, 3, or 4, followed by the [*] key.
8. The keypad displays “Press Remote”, “Button”.
9. Press the button on the remote.
10. If you are successful, the keypad will display “Success”, “Code UUUU ”.
11. Once you have finished, press the [#] key to exit programming.
LED Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The READY and ARM LEDs flash alternately.
3. Enter [MASTER CODE] followed by the [*] key.
4. The READY LED flashes.
5. Enter [2] [8] followed by the [*] key.
6. The READY and ARM LEDs flash simultaneously.
7. Enter [RECEIVER NUMBER] , which could be 1, 2, 3, or 4, followed by the [*] key.
8. The READY and AWAY LEDs flash simultaneously, and the ARM LED is on.
9. Press the button on the remote.
10. If you are successful the ARM and AWAY LEDs flash simultaneously, and the READY and POWER
LEDs flash simultaneously.
11. Once you have finished, press the [#] key to exit programming.
2.14 Remote Receiver Capacity
Use the following steps to view the capacity of the Remote Receiver
[*] [Master Code] [*] [2] [9] [*] [Receiver Number] [*] [#]
LCD Keypad
1. Hold the [*] key until the beep (3-4 seconds).
2. The keypad displays “Master Code + *”.
3. Enter [MASTER CODE] followed by the [*] key.
4. The keypad displays “Option Menu”, “Add User Code”.
5. Enter [2] [9] followed by the [*] key.
6. The keypad displays “Receiver Num + *”.
7. Enter [RECEIVER NUMBER] , which could be 1, 2, 3, or 4, followed by the [*] key.
8. The keypad displays “Remote Receivr N ”, “Used : UUU ”.
NOTE:
The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.
9. To identify more receivers repeat steps 7 and 8.
10. Once you have finished, press the [#] key to exit programming.