Section: 2
IDS X64 Remote Receiver 700-408-02A Issued August 2010
17
5.
Enter
[2] [6]
followed by the
[*]
key.
6.
The keypad displays “Receiver Num + *”.
7.
Enter
[RECEIVER NUMBER]
, which could be 1, 2, 3, or 4, followed by the
[*]
key.
8.
The keypad displays “Remote Receivr
N
”, “Confirm with *”.
9.
Press the
[*]
key.
10.
The keypad displays “Receiver Num + *”, “Defaulted Rx
N
”.
11.
To default additional receivers, repeat steps 7-10.
12.
Once you have finished, press the
[#]
key
to exit programming.
NOTE:
The keypad will beep 3 times and then repeat the beeps if the receiver is not registered.
LED Keypad
1.
Hold the
[*]
key until the beep (3-4 seconds).
2.
The READY and ARM LEDs flash alternately.
3.
Enter
[MASTER CODE]
followed by the
[*]
key.
4.
The READY LED flashes.
5.
Enter
[2] [6]
followed by the
[*]
key.
6.
The READY and ARM LEDs flash simultaneously.
7.
Enter
[RECEIVER NUMBER]
, which could be 1, 2, 3, or 4, followed by the
[*]
key.
8.
The READY and AWAY LEDs flash simultaneously, and the ARM LED is on.
9.
Press the
[*]
key.
10.
The ARM and AWAY LEDs flash simultaneously, and the READY and POWER LEDs flash
simultaneously.
11.
To default additional receivers, repeat step 7.
12.
Once you have finished, press the
[#]
key
to exit programming.
NOTE:
Remote Receiver 1 is indicated by zone LED 1 coming on.
Remote Receiver 2 is indicated by zone LED 2 coming on.
Remote Receiver 3 in indicated by zone LEDs 1 +2 coming on.
Remote Receiver 4 is indicated by zone LED 3 coming on.
2.12
Identify Remote Receiver
Use the following steps to identify the Remote Receiver.
NOTE:
Once registered, the Remote Receiver should respond to panel commands. To check, send the "Identify"
command to the Remote Receiver, and verify that both Remote Receiver LEDs flash.
This command may also be used to find or verify the number of a Remote Receiver, but is only useful
when the Remote Receiver cover is off.
[*] [Master Code] [*] [2] [7] [*] [Receiver Number] [*] [#]
LCD Keypad
1.
Hold the
[*]
key until the beep (3-4 seconds).
2.
The keypad displays “Master Code + *”.
3.
Enter
[MASTER CODE]
followed by the
[*]
key.
4.
The keypad displays “Option Menu”, “Add User Code”.
Summary of Contents for X64
