IDK MSD-5401, User Manual

Page: 216 / 271

MSD-54 SERIES User
’s Guide
216
■
MSD-5403
[Table 8.31] Factory default of Tally output connectors of MSD-5403
Pin No. Description Function Pin No. Description Function
1 +5V 26 +5V
2 OUT1-IN1
Selecting input
channel of OUT
1
*1
27 OUT3-IN4
Selecting input
channel of OUT
3
*1
3 OUT1-IN2 28 OUT3-IN5
4 OUT1-IN3 29 OUT3-IN6
5 OUT1-IN4 30 OUT3-IN7
6 OUT1-IN5 31 OUT3-IN8
7 OUT1-IN6 32 OUT3-IN9
8 OUT1-IN7 33 OUT3-OFF
9 OUT1-IN8 34 SWITCHING
–V&A
Selecting
channel
switching mode
*2
10 OUT1-IN9 35 SWITCHING
–VIDEO
11 OUT1-OFF 36 SWITCHING
–AUDIO
12 OUT2-IN1
Selecting input
channel of OUT
2
*1
37 COMMAND A
Sending control
commands
*3
13 OUT2-IN2 38 COMMAND B
14 OUT2-IN3 39 COMMAND C
15 OUT2-IN4 40 COMMAND D
16 OUT2-IN5 41 COMMAND E
17 OUT2-IN6 42 COMMAND F
18 OUT2-IN7 43 COMMAND G
19 OUT2-IN8 44 COMMAND H
20 OUT2-IN9 45 COMMAND I
21 OUT2-OFF 46
DISPLAY1 POWER
ON
Controlling
display power of
OUT 1
*4
22 OUT3-IN1
Selecting input
channel of OUT
3
*1
47
DISPLAY2 POWER
ON
Controlling
display power of
OUT 2
*4
23 OUT3-IN2 48
DISPLAY3 POWER
ON
Controlling
display power of
OUT 1
*4
24 OUT3-IN3 49 PARALLEL LOCK
Controlling
display power of
OUT 2
*5
25 GND 50 GND
*1
Pins for the currently selected channels are pulled to ground, allowing current to flow through them.
Output target of video and audio depends on channel switching mode. (If video and audio channels are not
the same and ”V&A” is selected for channel switching mode, the video channel is output.)
*2
Pins for the switching mode channels currently selected in parallel are pulled to ground.
*3
Control commands that are registered in COMMANDs A to I are pulled to ground. However, each command
execution condition (COMMAND A to I) has two planes (PLANE A and PLANE B). If control commands are
registered in both planes, the control commands are executed alternately every time parallel input of
COMMAND A to I is turned ON/OFF. If PLANE A is set to be executed at the next parallel input ON, it is
pulled to ground (lights); if PLANE B is set to be executed at the next parallel input ON, ground is set
ON/OFF alternately (blinks).
Ground can only be output when the control command is executed according to the setting of
“8.12.7
Command key setting”
. Ground is set ON/OFF alternately (blinks) when control commands are executed
according to the setting of
“8.12.8 Flash time (Command keys and DISPLAY POWER keys)”
.
*4
Pins are pulled to ground when the MSD is turned on.
*5
Pin is pulled to ground while parallel input is locked.