DFS-01UHD / DFS-01HD User’s Guide
30
8.4.3 HDCP
Menu Top
→
OUTPUT SETTING
→
OUTPUT HDCP MODE
Setting value
AUTO
: Encrypts HDCP at all times [Default]
INPUT ONLY : Encrypts HDPC only if input signal is HDCP-compliant
You can set the HDCP output for when an HDCP-compliant sink device is connected.
Normally set this menu to “AUTO” to output HDCP at all times regardless of input signal state.
If you select “INPUT ONLY”, the DFS encrypts HDCP only if the input signal has HDCP. Video and audio may
not be output temporarily in some monitors if HDCP is changed from OFF to ON.
Notes:
・
HDCP2.2 (stream type 0) contents can be displayed on sink devices supporting HDCP1.4.
・
HDCP2.2 (stream type 1) contents can be displayed on sink devices supporting HDCP2.2 but cannot be
displayed on sink devices supporting HDCP1.4.
8.4.4 Hotplug mask
Menu Top
→
OUTPUT SETTING
→
OUTPUT HPD MASK
Setting value
OFF : 0 second [Default]
2Sec to 15Sec : 2 to 15 seconds
Time for ignoring the video output request signals sent from the sink device.
If the request signals are repeated in a short cycle, the DFS processes video output from the first cycle. As a
result, video may not be output. This problem can be solved by setting the ignoring time.
8.4.5 Deep Color
Menu Top
→
OUTPUT SETTING
→
OUTPUT DEEP COLOR
Setting value 24Bit [Default], 30Bit
You can select the color depth of HDMI signal.
“30Bit”: Signals are output at 30 bit / pixel (10 bit / component) only if a sink device supporting Deep Color is
connected. Since the transmission clock of 30 bit / pixel (10 bit / component) is faster than that of24 bit / pixel
(8 bit / component), noise may occur if a poor-quality cable or long cable is connected. In those cases, the
noise may be removed by selecting”24Bit”.
For 2560x1440, 2560x1600, 3840x2160, and 4096x2160, the color depth will be 24 bit / pixel (8 bit /
component).
