Operator Manual Aspect 100UC Plus
L100-3065 REV C
pin is in good condition. Check that the cord ground wire is securely connected to the
ground stud inside the unit.
During an AC failure, the table will automatically run on battery backup without any
manual switching required. It is recommended that power be applied at all times, even
when not in use, to keep a proper charge on the batteries and achieve maximum battery
life. (Batteries are being charged during normal use).
Where the integrity of the external protective earth conductor is in doubt, this equipment
shall be operated from its internal electrical power source by unplugging the power cord
from the mains.
Preparation for Patient Use
New Installation:
This equipment will need to be properly cleaned before patient use as it will inevitably come in
contact with contaminants during shipping, unpacking, storage, and installation.
After Installation:
This equipment will need to be properly cleaned between patient use as it will inevitably come
into contact with contaminants during procedures.
Preparation for Performing CPR
Return table to level position, lower table to a comfortable height and
verify that patients head is located at handle end before performing
CPR on a patient. Image Diagnostics recommends
prior to placing
table into service, facility/operators create a procedure for positioning the
table for possible CPR events.
CPR should
not
be performed on the 100UC
Tabletop Extension.
Review the SAFETY INSTRUCTIONS before
operating table
