Idexx SNAPshot Dx, Operator'S Manual

Page: 5 / 43

v
Preface
Safety Precautions
• The IDEXX SNAPshot Dx* Analyzer contains no user-serviceable components. DO NOT
disassemble. Call IDEXX Technical Support for any service issues.
• Do not insert anything in the SNAP* ports except devices approved for use with the SNAPshot
Dx Analyzer.
• Do not insert anything in the incubator wells except for the plastic sample tubes provided in
the SNAP test kits.
• DO NOT stack other equipment or containers on top of the analyzer.
• Keep analyzer away from sources of heat or flames.
• DO NOT place or operate the analyzer near x-ray equipment, photocopiers, or other devices
that generate static or magnetic fields.
• PROTECT your equipment from damp conditions or wet weather.
• Take care not to spill water or other fluids on the analyzer.
• DO NOT use any of the following liquids, abrasives, or aerosol sprays on or near the analyzer,
as they may damage the outer case and may influence the results:
– Organic solvents
– Ammonia-based cleaners
– Ink markers
– Sprays containing volatile liquids
– Insecticides
– Disinfectant
– Polish
– Room freshener
• Line voltage for the SNAPshot Dx Analyzer power supply is 100–240 V AC, 50–60 Hz.
Be sure to plug all equipment into properly grounded electrical outlets.
• Use only the power cable supplied.
• Disconnect the power cable from the AC power outlet:
– If the power cable becomes frayed or otherwise damaged.
– If anything is spilled onto the equipment.
– If your equipment is exposed to excessive moisture.
– If your equipment is dropped or the case has been damaged.
– If you suspect that your analyzer needs service or repair.
– Whenever you clean the case.
• If the equipment is used in a manner other than specified, the protection provided by the
equipment may be impaired.