Page 6 of 12
0900885 Rev: REL (02/06)
PRE-INSTALLATION
Before the equipment is installed, you should survey the installation site thoroughly. Listed below are some of the
factors to consider when picking your location.
Work Area — the unit should be mounted in centralized area to work areas.
Chemical location — unit should be mounted close to the chemical tanks. For bulk tank installations, pumps must
be placed on, or near tanks.
Mounting surface — ensure there is a sturdy wall (or panel) with enough space for all system components and
routing of chemical tubes, air lines, and cables.
Electrical — requires 115 VAC/60 Hz power source, 1 amp service for air pump only applications (20 amp
service recommended if using peristaltic pumps).
Air Service — required for operation of air pumps and anti-siphon valves (optional if manifold is used). Available
air pressure should be 70 PSI and 12 SCFM. Check specification of air compressor on site for adequate air flow.
Water Service — system requires ambient water service to flush manifold (if so equipped). Recommended
minimum 25 PSI flow pressure.
Familiarize yourself with all applicable safety, electrical, and plumbing codes.
CONTROL BOX & POWER SUPPLY INSTALLATION
(1) Mount the joggle bracket to the wall at a height that all users can access and read the display screen. Use the
hardware in the accy kit or other appropriate hardware for the mounting surface.
(2) Hang the control box unit on the joggle bracket. Secure the control box to the wall with provided hardware.
(3) Mount the power supply box in close proximity to the control box unit.
(4) Connect main power from a suitable breaker to the power input terminal block inside the power supply box, and
per local wiring codes.
(5) Connect power from the power supply box to the appropriate terminals on the main control board inside the
control box using the cable provided (see wiring diagram in this manual for details).
(6) Connect air line to input fitting on the air filter inside the control box. Hardware not provided.
(7) Connect water supply (if flush will be used). Hardware not provided.
