45
10
SETTINGS
10.1
Handset Registration
IMPORTANT:
When you purchase your phone system, all handsets are
already pre-registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if
a handset has become faulty.
You can register up to four handsets to one base station, with each
handset’s number (1 to 4) shown on its display.
Note:
Each handset can only be registered to one base.
You need to enter the Master PIN before you can register or deregister
handsets. The default Master PIN is
0000
.
10.2
Register ECLIPSE Handset
-
For a ECLIPSE Type Handset
1.
Press and hold the key under the base unit for approximately 5 seconds.
•
The message indicator on the base will flash for up to 1 minute,
while it is in registration mode.
2.
On the handset, press
.
3.
Press
/
to
SETTINGS
and then press
to select.
4.
Press
/
to
REGISTRATION
and then press
to
select.
5.
Enter the Master PIN and then press
to confirm.
Note:
After entering the Master PIN on either the ECLIPSE Handset,
•
WAITING
flashes on the screen.
•
A confirmation tone is played to
indicate successful registration,
and the handset returns to standby mode, with its handset number
displayed.
•
If no base is found with the entered PIN, error tones are played to
indicate failed registration and
PLS REG H/S
is displayed on the
screen. You will need to repeat from step 1 above.
•
During steps 2-5, if no key is pressed on the handset within 10
seconds, the registration
procedure will be aborted. If this happens,
repeat from step 1 above.
Summary of Contents for eclipse 8035
Page 1: ......
Page 36: ...34 4 Press again to confirm A confirmation tone played ...
Page 44: ...42 6 Press to return to standby mode ...
Page 69: ...67 ...
