IDEC SmartRelay FL1D Series, User Manual, Page: 249 / 336

Configuring IDEC SmartRelay
239
IDEC SmartRelay Manual
To set the TOD and the date in programming mode:
If you want to set the TOD and the date in programming
mode, select ‘ Setup ’ in the main menu, then menus ‘ Clock ’
and ‘ Set Clock ’. You can now set the weekday and the time
as described earlier (as of step 8.).
5.2.2 Setting the display contrast
You can set the default value for the display contrast
• in parameter assignment mode by means of the set menu
(“Contrast” menu item)
• in programming mode by means of the setup menu
(“Contrast” menu item).
To set the display contrast in parameter assignment mode:
1. Select parameter assignment mode (see Chapter 5.1.)
2. On the parameter assignment menu, select ‘
Set.. ’:
Press
▼
or
▲
3. Confirm ‘Set..’: Press OK
4. Move the ‘>’ cursor to ‘ Contrast ’: Press
▲
or
▼
5. Confirm ‘Contrast’: Press OK
IDEC SmartRelay shows the following display:
Contrast
–
.... ....
+
6. To change the display contrast: Press or
7. To confirm your entry: Press OK
To set the display contrast in programming mode:
If you want to set the display contrast in programming mode,
select ‘ Setup ’ in the main menu, then menu ‘ Contrast ’. You
can now set the display contrast as described earlier (as of
step 6.).
▼
▼
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com