Configuring IDEC SmartRelay
IDEC SmartRelay Manual
234
5.1.3
Modifying parameters
You first select the parameter you want to edit (see Chapter
5.1.2).
You change the value of the parameter in the same way as
you did in programming mode:
1. Move the cursor to the point at which you want to make
the change:
Press or
2. To change this value:
Press
▲
or
▼
3. To apply the value:
OK
Note
When changing the time parameters when the system is in RUN,
you can also change the timebase (s = seconds, m = minutes, h =
hours). This does not apply if the time parameter represents the re-
sult of another function (for an example, see Chapter 4.4.1). In this
case you can neither change the value nor the timebase.
The current time is reset to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
B9
Ta =06:00s
T
=80:00s
Configured time T
Current time T
a
You can change the configured time T.
▲
▲
B9
Ta =06:00s
T
=80:00s
Change: Press
▲
or
▼
Move: Press or
Done:
OK
▲
▲
Courtesy of Steven Engineering, Inc. ● 230 Ryan Way, South San Francisco, CA 94080-6370 ● General Inquiries: (800) 670-4183 ● www.stevenengineering.com