IDEC SE2L Series, User Manual

Page: 95 / 152

SE2L User’s Manual (SE9Z-B1865)
94
Table 7-12 Function
Tab Item Description
Sensing
Check to enable the sensing function
 Min detection width
*
1
(mm) 30 (Default), 50, 70
 Active areas
*
2
: Area 1 to Area 32 (Default)

Area input delay :30ms (Default), 120ms, 270ms, 1s,2s
 Operation mode : Protection 1 + Warning 1/2, Protection 1, 2
EDM
Check to enable the EDM function

On delay(ms): 90 (Default), 120, 300

Off delay(ms): 300 (Default), 330, 360
* In dual protection mode, EDM1 and EDM2 can be configured
independently.
Interlock
Check to enable the Interlock function
 Start/Restart mode : Manual/Automatic, Manual/Manual
 Delay(s): 1(Default) to 6
* In dual protection mode, interlock can be independently configured
for protection zone 1 and protection zone 2.
Reference monitor
Check to enable the Reference monitor function
Tolerance(mm): 100 (Default) to 10000
Muting
Check to enable the Muting function
 Muting input sequence:
Muting 1  Muting 2 (Default), Muting 2  Muting 1 (Protection zone 1)
Muting 3  Muting 4 (Default), Muting 4  Muting 3 (Protection zone 2)
 Time interval between inputs(s): 1(Default), 3, 5, 10
 Max. muting period(min): 1(Default), 6, 12 and Infinity
 Max. override period(min): 1(Default), 6,12
* In dual protection mode, muting can be independently configured for
protection zone 1 and protection zone 2.
Area sequence
*
3
Check to enable the Area sequence function
 The check box of the area sequence possible area will be valid
 The check box for all area will be valid
Master Slave
Check to enable Master Slave function
Current device
*
4
: Master, (Default) Slave1, Slave2, Slave3

Slave count : 1 (Default) to 3 (For Master only)

Use own OSSD outputs (For slave only)
Function
Encoder Input
Check to enable the Encoder Input function
 Error tolerance : 0 to 45 %
 Encoder pulse 1 : 50 to 1000 (count/cm)
 Encoder pulse 2 : 50 to 1000 (count/cm)
 Select patterns: Each pattern can be selected from Not Use, Use as
Static input and Use as Encoder input.
 Detailed area setting for each pattern.
For the encoder input set speed division count and area for each speed
range. It is not possible to select same area for two different speeds.
For static input, select the area and enable or disable speed monitoring.
If speed monitoring is enabled it is necessary to provide the speed
range.
*1: The minimum width of detectable objects. Detection is not possible if configured width is more than the
object intended to be detected.