Ideal-Tridon Strapbinder, Operation, Parts And Safety Manual

Page: 16 / 40

4. Once the cycle completes rotate tool or clamp until the
band is rotated past 90 degrees.
5. Push/pull the handle to actuate the cutter.
6. Once the band is cut the tail of the strap can be
removed from the tool by squeezing the handle.
7. The tail is then folded until it lies below the tip of the
tabs. Once this occurs the tabs are hammered down.
Apply additional clamps as needed.
8. Inspect and test the completed hose assembly. All hoses must be tested to manufacturer’s
specifications, NAHAD 5.7.1 test procedures for Industrial hose and application requirements.
See NAHAD 5.6.11 for additional information regarding preform clamps. Additional testing may
be required for alternate applications.
16