IDEAL Networks NaviTEK NT, User Manual

Page: 6 / 30

NaviTEK NT 153800 Iss 1
User Guide Page 6
Switching ON and OFF
To switch the tester ON, press and hold the Power button. Wait until the home screen is
visible on the display; the tester is ready for use.
To switch the tester OFF, press and hold the Power for approximately 1/2 second, a shutdown
message is displayed on the screen. The currently stored setup is saved.
Power Saving
Power saving preferences are selected from SETUP>SYSTEM>PREF. Auto off can be Disabled
(tester remains ON indefinitely), or set to switch the tester OFF after three, 10 or 30 minutes
of inactivity. The backlight can be set to Always On, or to dim to 50% brightness after three
minutes of inactivity. Note that when mains power is connected the display is always on full
brightness and the tester remains ON indefinitely.
Master Reset
In the unlikely event of a system lock-up which prevents the tester from being switched OFF,
it may be necessary to perform a master reset. This will not delete any stored data.
•
Remove the power module or battery pack to access a small aperture in the NaviTEK
NT (Fig 2).
• Insert a paper clip into the reset hole and press the internal reset switch.
Fig 2
• Replace the power module or battery pack.