NaviTEK II
151810 Iss 1
User Guide
Page 19
Note that for the example of a Wiremap test shown above; if the
option ‘XOver Allowed’ had been checked
in the Wiremap SETUP options, the results would be displayed as shown in Fig 17 and Fig 18.
Fig 17
Fig 18
The wiremap tests may be run with no termination
– open, or with an Active Remote termination. When
connected, an image of an Active Remote will be shown on the display and its type identified. After a test
has been run, the length of the cable is displayed (range up to 100m (330ft)).
With an open termination the possible faults detected are:
Fig 19 Open circuit by pair
Fig 20 Short circuit by pin
www.vemco.pl
