151810 Iss 1
NaviTEK II
Page 10
User Guide
Press the soft key DETECT (F1) and the tester will determine the mode of operation dependent on the
services detected.
The modes of operation that follow are available:
NaviTEK II has two fundamental modes of operation
–
Cable
When the tester is connected to a copper cable,
with or without an active remote, press the soft
key DETECT (F1) to display all options
available from the Cable mode screen (Fig 6).
When an active remote is connected it will be
shown on screen and its identification number
displayed. For a full description of these
options, see -
Fig 6
Ethernet
Fig 7
When the tester is connected to a network/device,
using either copper or fiber cable, press the soft key
DETECT (F1), to display all options available from
the Ethernet mode screen (Fig 7). For a full
description of these options see
–
The detected services are PoE (802.3af/at. Not
Cisco pre-standard), ISDN S, PBX and Unknown.
The IPv4 and IPv6 addresses assigned to the tester
are displayed (when available).
www.vemco.pl
