![background image](http://html1.mh-extra.com/html/idatalink/ads-tbsl-pl/ads-tbsl-pl_install-manual_3581816015.webp)
TyPe 12 - wiring diagram
Page 15 of 19
ADS-TBSL-PL
20110120
install guide
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2011
Transponder Bypass
PASSLOCK
MOVE THE FOLLOWING ITEMS IN YOUR
SCHEMATIC WITH ALL LAYERS ON
USE THE FOLLOWING LAYER SPECIFIC ITEMS AS
WIRING AND TEXT TEMPLATES
IDATALINK (RS232) PORT REQUIRED
ON REMOTE STARTER. IF UNAVAILABLE
USE STANDARD WIRING METHOD
LEGEND
Wiring connections not required
when installed in iDatalink mode
* Wiring connection not required in
2-way iDatalink
PASSLOCK
REFERENCE
MAIN IGNITION HARNESS CONNECTOR
LOCATED AT IGNITION BARREL
BLUE/RED - STARTER INPUT (+)
BLUE/YELLOW - TO WHITE
GREEN/RED (NC)
GREEN/YELLOW (NC)
GRAY/RED - TO WHITE/RED
GRAY/YELLOW - GROUND
ORANGE (NC)
PINK/BLACK (NC)
PINK - REFERENCE INPUT
WHITE/BLA
CK - P
ASSL
OCK
WHITE/RED - T
O GREY/RED
WHITE - T
O BLUE/YELL
O
W
RED - 12V
BLACK - GROUND
NO WIRE (NC)
BLUE/WHITE - GROUND-OUT WHEN RUNNING
REMOTE
STARTER
CONNECT TO REMOTE STARTER
(+) STARTER OUTPUT
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
IDATALINK
NOTE
STANDARD 12 VOLT, IGNITION AND ACCESSORY
STILL REQUIRED FROM THE REMOTE STARTER.
MULTIPLEX CIRCUIT IS CONTROLLED FROM
MODULE USING DATA, THEREFORE NO ADDITIONAL
RELAYS OR RESISTORS REQUIRED.
NOTE
STANDARD 12 VOLT, IGNITION AND ACCESSORY
STILL REQUIRED FROM THE REMOTE STARTER.
MULTIPLEX CIRCUIT IS CONTROLLED FROM
MODULE USING DATA, THEREFORE NO ADDITIONAL
RELAYS OR RESISTORS REQUIRED.
NOTE
STANDARD 12 VOLT, IGNITION AND ACCESSORY
STILL REQUIRED FROM THE REMOTE STARTER.
MULTIPLEX CIRCUIT IS CONTROLLED FROM
MODULE USING DATA, THEREFORE NO ADDITIONAL
RELAYS OR RESISTORS REQUIRED.
NOTE
STANDARD 12 VOLT, IGNITION AND ACCESSORY
STILL REQUIRED FROM THE REMOTE STARTER.
MULTIPLEX CIRCUIT IS CONTROLLED FROM
MODULE USING DATA, THEREFORE NO ADDITIONAL
RELAYS OR RESISTORS REQUIRED.
NOTE
STANDARD 12 VOLT, IGNITION AND ACCESSORY
STILL REQUIRED FROM THE REMOTE STARTER.
MULTIPLEX CIRCUIT IS CONTROLLED FROM
MODULE USING DATA, THEREFORE NO ADDITIONAL
RELAYS OR RESISTORS REQUIRED.
5-6 LOOPS
AROUND KEYFOB
5-6 LOOPS
AROUND KEYBARREL
30
87
87A
86
12V
GWR (-)
NOTE
INSTALL ONLY
IF VEHICLE IS EQUIPPED
WITH TRANSPONDER
Doc. No.: ##4684##