TyPe 1 - wiring diagram
TyPe 2 - wiring diagram
Page 6 of 19
ADS-TBSL-PL
20110120
install guide
guides Français disponibles au www.idatalink.com
www.idatalink.com/support
automotive data solutions inc. © 2011
Transponder Bypass
PASSLOCK
MOVE THE FOLLOWING ITEMS IN YOUR
SCHEMATIC WITH ALL LAYERS ON
USE THE FOLLOWING LAYER SPECIFIC ITEMS AS
WIRING AND TEXT TEMPLATES
IDATALINK (RS232) PORT REQUIRED
ON REMOTE STARTER. IF UNAVAILABLE
USE STANDARD WIRING METHOD
LEGEND
Wiring connections not required
when installed in iDatalink mode
* Wiring connection not required in
2-way iDatalink
BLUE/RED - STARTER INPUT
BLUE/YELLOW - BULBTEST
GREEN/RED (NC)
GREEN/YELLOW (NC)
GRAY/RED - PASSLOCK (1 TO 4 VOLTS)
GRAY/YELLOW - PASSLOCK GROUND
ORANGE (NC)
PINK/BLACK (NC)
PINK - IGNITION INPUT
WHITE/BLA
CK (NC)
WHITE/RED (NC) WHITE (NC)
RED - 12V
BLACK - GROUND
NO WIRE (NC)
BLUE/WHITE - GROUND-OUT WHEN RUNNING
MAIN IGNITION HARNESS
PASSLOCK 1
BLACK (GROUND)
YELLOW OR BLACK (1 TO 4 VOLTS)
BLACK/WHITE OR WHITE
BLACK (BULBTEST)
PINK (IGNITION)
YELLOW (STARTER)
KEY
REMOTE
STARTER
***WARNING***
MAKE SURE THE REMOTE STARTER (+) START WIRE IS
CONNECTED TO THE IGNITION HARNESS WITH THE
IDATALINK BLUE/RED (+) STARTER INPUT (NOT ON
THE OTHER SIDE OF THE CLUTCH PEDAL SWITCH)
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
IDATALINK
MOVE THE FOLLOWING ITEMS IN YOUR
SCHEMATIC WITH ALL LAYERS ON
USE THE FOLLOWING LAYER SPECIFIC ITEMS AS
WIRING AND TEXT TEMPLATES
IDATALINK (RS232) PORT REQUIRED
ON REMOTE STARTER. IF UNAVAILABLE
USE STANDARD WIRING METHOD
BLUE/RED (NC)
BLUE/YELLOW (NC)
GREEN/RED (NC)
GREEN/YELLOW (NC)
GRAY/RED - VATS (1 TO 5 VOLTS)
GRAY/YELLOW - VATS GROUND
ORANGE (NC)
PINK/BLACK (NC)
PINK - IGNITION INPUT
WHITE/BLA
CK (NC)
WHITE/RED (NC) WHITE (NC)
RED - 12V
BLACK - GROUND
NO WIRE (NC)
BLUE/WHITE - GROUND-OUT WHEN RUNNING
VATS WIRES ARE LOCATED IN
AN ORANGE OR GRAY SLEEVE
KEY
VATS
VATS GROUND
VATS (1 TO 5 VOLTS)
REMOTE
STARTER
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
IDATALINK
LEGEND
Wiring connections not required
when installed in iDatalink mode
* Wiring connection not required in
2-way iDatalink
Doc. No.: ##4684##
