PRT-PX16-PCB
Protege 16 PGM Output Expander
Installation Manual | June 2017
25
8
Error Code Indication
When the Output Expander attempts to register or communicate with the system controller a registration error
can be generated indicating that it was not successful.
8.1
Error Code Display
The following table is only valid if the FAULT indicator is CONSTANTLY ON and the STATUS indicator is
FLASHING RED.
If the fault indicator is FLASHING the Output Expander requires a firmware update or is currently in firmware
update mode.
The status indicator will FLASH RED with the error code number. The error code number is shown with a
250ms ON and OFF period (duty cycle) with a delay of 1.5 seconds between each display cycle.
Flash
Error Description
1
Unknown Error Code
The error code returned by the system controller could not be understood by the Output
Expander. Contact Integrated Control Technology.
2
Firmware Version
The firmware version on the Output Expander is not compatible with the system controller.
To clear this error, update the module using the module update application.
3
Address Too High
The Output Expander address is above the maximum number available on the system
controller. To clear this error change the address to one within the range set on the system
controller, restart the Output Expander by disconnecting the power.
4
Address In Use
The Address is already in use by another Output Expander. To clear this error set the
address to one that is not currently occupied. Use the view network status command to list
the attached devices, or the network update command to refresh the registered device list.
5
Controller Secured Registration Not Allowed
Controller is not accepting any module registrations. To allow module registrations use the
network secure command to change the secure setting to not secured.
6
Serial Number Fault
The serial number in the device is not valid. Return the unit to the distributor for
replacement.
7
Locked Device
The Output Expander or system controller is a locked device and cannot communicate on
the network. Return the unit to the distributor for replacement.
