CRX-POSTX-DIN
DIN Rail PostX IP Reporting Module
Installation Manual | June 2017
39
12
Command Line Interface
The PostX Module provides a command line interface to help with setup diagnostics. This can be accessed
through a Telnet session (Ethernet) or through a serial port connection. The following instructions detail how to
establish a Telnet session.
1.
Open a command prompt (Click Start | Run, then type "cmd" into this window and click "OK").
2.
Type telnet 192.168.1.2 9000 into the command prompt and press ENTER.
3.
Wait for the command prompt to respond. The command prompt "ICTNET>" will come up when a
connection has been established. To terminate the telnet session, type "exit" into the command prompt.
Starting a Telnet Session
If not using Ethernet the command line interface can be accessed through the RS485 interface.
To start using the RS485 interface, apply DC power to the PostX Module and connect the ACC-485 to both the
PostX Module and an available RS232 serial port on your computer. Open a terminal program such as
HyperTerminal or TeraTerm with the baud rate set to 38400 (38400, 8, n, 1). Press ENTER or ESC to get the
command prompt.